DB-CPLD-PL BOARD

The Testing and Programming Board DB-CPLD-PL is determined for programming and testing all XILINX XC9500 family devices in PLCC44 and PLCC84 packages in co-operation with XILINX development software Foundation or Alliance. Board can be connected to PC in two ways:

• connection to serial port using XChecker Cable
• connection to parallel port using Parallel Cable III (delivered with development systems)

Power supply

Tested devices can be inserted together in two sockets in the same time.

There are four power supply options :

	Power supply Connection Jumper J10 Jumper "short" Notes stabilised 5V connector ARK120/3 connected pins2 and 3 disconnected standard stabilised 5V and  3,3V connector ARK120/3 disconnected pins 2 and 3 disconnected compatibility I/O drivers with  3,3V supply voltage unstabilised up to 20V connector K1-JACK 3,5mm(plus pole in the middle) connected pins2 and 3 connected unstabilised up to 20Vand  3,3V power supply connector K1-JACK 3,5mm+ connector ARK120/3 disconnected pins 2 and 3 connected compatibility I/O drivers with  3,3V supply voltage

Possibility of usage:

• erasing and checking ERASE, BLANK CHECK
• programming and checking PROGRAM, VERIFY
• device type identification check DEVICE ID
• device user signature check USER SIGNATURE
• programming of the read and write permission SECURITY BIT , READ, WRITE

Prices

General information

DB-CPLD-PL board for XILINX XC9500 family devices is product of ASICentrum company. Any copying and production without written ASICentrum’s authorization is strictly prohibited.